Reseñas de clientes para VEVOR Abrazadera de Horquillas de Tractor 109 cm Abrazadera en Horquillas de Paletas Carga de 907 kg Barra Estabilizadora Ajustable Horquilla de Paletas para Carretilla Elevadora con Pala Cargadora

These came in handy when we had material delivered to the farm. They will tend to losen after some use so keep a rubber mallet close by to tighten them back. The brace is great for setting the width, but I found it takes away from the depth when picking up pallets. I'm pleased with them for the occasional use.

I find that the pallet forks would be better if they actually bolted through the bucket. I can't get them tight enough to keep them from moving. I am satisfied with the weight that I can pick up with them

They work great for the price. I wouldn't push them too hard but I have lifted over 1000# without an issue. Would buy again for the price.

OK for price but cross member broke on first use. will have to weld on stronger box section

Had high hopes that these would work for doing some lifting of pallets with my Kubota 7800. Tractor had no problem lifting, but the screws on the other hand both had issues. Both bent to a point I can't get them out to replace and one fork bent where I attached a chain to improve stability, the chain bent the metal. Yes I screwed the fork to the bucket and then tightened the bolt. Yes the forks were fully inserted onto the bucket.

El producto llegó bien y pronto. El soporte para la pala y las propias pinzas endebles para los bque yo quiero. Las pinzas se quedan cortas para coger los palets normales y endebles para los 1.000 kg. Cómo podéis ver en la foto los soportes de sujeción se han abierto y el soporte de unión ya está doblado después de utilizarlo en poco uso.

Forks are good but the bolts that clamp on the bucket bend very easy :( Maybe user error but I'm sure the were secure before I moved the logs and pallets Welds on nuts broke so maybe that was the problem and it happened on both forks at seperate times

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I found the forks absolutely useless and a complete waste of money!!! First, I had to file the divider down to fit it over the forks. Second, When I tightened the bolt to keep the divider at a constant width, it snapped quite easterly and Third, The forks wouldn't stay tight on the FEL bucket, it didn't matter how tight I initially tightened them. Typical CHINESE RUBBISH, I should have known better. I would be VERY hesitant to buy anything from Vevor again.

They are a pain in the A## to use, always slipping, even with a plate under the hold down area, they bent my bucket. I will be welding them permanently to a plate