Reseñas de clientes para VEVOR Abrazadera de Horquillas de Tractor 149 cm Abrazadera en Horquillas de Paletas Carga de 1814 kg Barra Estabilizadora Ajustable Horquilla de Paletas para Carretilla Elevadora con Pala Cargadora

Get what you pay for within a couple days the paint on the forks flaked off peeled off. Tighteners are difficult to work with. If you can afford it by high-end.

OK for price but cross member broke on first use. will have to weld on stronger box section

Was moving rafters and some how bent one of the blocks that tighten it down with my 35 hp tractor

I was disappointed when I got these. The pads used for the mounting screws are just nuts loosely threaded on. When you go to tighten them, the nuts spin on the screw and will move up. When you loosen, the nuts fall right off. Very cheap design. If you are putting the forks on one time and leaving them, it would be okay. But if you are constantly taking them on and off, it is a big deal.

Had high hopes that these would work for doing some lifting of pallets with my Kubota 7800. Tractor had no problem lifting, but the screws on the other hand both had issues. Both bent to a point I can't get them out to replace and one fork bent where I attached a chain to improve stability, the chain bent the metal. Yes I screwed the fork to the bucket and then tightened the bolt. Yes the forks were fully inserted onto the bucket.

El producto llegó bien y pronto. El soporte para la pala y las propias pinzas endebles para los bque yo quiero. Las pinzas se quedan cortas para coger los palets normales y endebles para los 1.000 kg. Cómo podéis ver en la foto los soportes de sujeción se han abierto y el soporte de unión ya está doblado después de utilizarlo en poco uso.

Forks are good but the bolts that clamp on the bucket bend very easy :( Maybe user error but I'm sure the were secure before I moved the logs and pallets Welds on nuts broke so maybe that was the problem and it happened on both forks at seperate times

I bought these forks because they looked like a perfect fit for my New Holland tractor. Looked perfect when unpacking however I ran into a problem. When trying to attach my lower control arms I found the holes drilled on the bracket were too close to the frame of the fork attachment. I could not put the pin in, the holes should have been an inch farther from the frame. Not sure if I should return or remove and weld on new steel brackets that are a little longer. I willl attach the picture. I the lower arm will be beside the bracket for the picture to show distance is not large enough

It work

Item came as pictured, when unboxes i seen the box profile was 3mm wall, i expected 5-6mm wall for the rated weight it should handle, i will be welding on some flat to the sides for extra strength. The first time i used them the bolts to tighten to the bucket bent due to the gap allowing too much movement. I again will need to modify the gap and update the bolt size. Nice idea for a product but in my opinion as standard only fit for very light use.