Reseñas de clientes para VEVOR Abrazadera de Horquillas de Tractor 149 cm Abrazadera en Horquillas de Paletas Carga de 1814 kg Barra Estabilizadora Ajustable Horquilla de Paletas para Carretilla Elevadora con Pala Cargadora

These are a lot easier to use than the 4 x 4‘s. I used to bolt onto my tractor bucket and if I use these on concrete picking up pallets, they would be great. But I use them in dirt and the tips on these forks point down and dig into the dirt when I lower my tractor bucket. Please reverse the angle on the tips so that it keeps me from digging into the dirt when I grab a load of brush. But again, thank you. It’s way better than the 4 x 4 post that I was putting on there.

Overall awesome product! Quick shipping, simple design, replaced wing screws with bolts easier to lock down so there's no play. just making sure the plates are in the right spot and to make sure they are clamped on the bucket good is the only tricky part.

Super outils mais j'ai du faire une modification car le système fournit a trop de jeu, ce qui le rend fragile, les tiges pour le système 3 points, pour reprendre sur le levage du tracteur sont trop fines, donc j'en ai mis des plus grosses filtées et fixes pour justement éviter le jeu . Mais sinon à part ça, je lève des palettes et du matériel de plus de 400kg avec, ça fait le job. Je joins quelques photos entrain de lever du bois avec

I am overall pleased with the item. Unfortunately they did not come the advertised safety chains shown and there is an opening in the top of forks. This area collects rain water easily and started rusting inside that area. I’ve only owned them for a month so I’m a bit disappointed in quality.

Only used once so far, but worked well and looks to be of good quality.

Gets the job done and can't beat the price. Out of the box one of the set screws for mounting was a little screwy, but I carry a little Hammer on my machine. One tip, my machine only lifts about 1200 pounds and I almost ordered th 2k forks but went with the 4k because the price difference wasn't a far off. Im glad I did.

The forks are very sturdy. Better than I expected. Unfortunately the stabilizer bar broke the first time I used it. The stabilizer bar is pretty much required to keep the forks from moving out of parallel. If the stabilizer bar can be improved this would be a very good value. Without it, I have to keep straightening the forks from moving side to side.

It takes some time and effort to attach. I think some welding of the brackets might make it easier. Also, the nuts on the clamps fall off. Again, a tack weld should rectify that issue.

Good for the price

Nice quality, and easy to use, but I have a hard time tightening them enough that they don't move on bucket. Might have to drill holes for the bolts to grab.