Reseñas de clientes para VEVOR Calentador Coche Diésel de 3 kW Calentador Diésel Eléctrico de Aluminio 12 V Calentador de Estacionamiento con Ahorro de Energía Calentadores

This is the third cheap diesel heater I have owned so far. The first one I had worked well for a few years without any issues until It quit. I decided to replace and buy another instead of diagnosing the problem. These are cheap and I figured I would keep the old one for parts. in the process I ended up with a unit that was a real POS, and learned all about error codes and different mother boards. I also learned that the mosfet for the glow plug can be suspect for an error code 3 (glow plug error), and you should always have a spare glow plug.This 3kw happy buy is the third one and Im happy with it. The dial controller keeps things simple, and the heater has the light blue mother board (pcb). This is to say that the dial controller works with the blue pcb- hopefully that helps someone. When looking to replace controllers its never a guarantee it will work with the motherboard. The 3kw puts out plenty of heat, and has kept my van 75 degrees when its well below freezing outside. When I first decided to get one of these I figured they were 10% of the cost of an Esbar or Webasto, so I could buy 10 of the cheap ones and still be in the clear. I guess I can get 7 more but I the time on install is lost to eternity. Since I had the broke second one I learned more on how to fix. Good knowledge when fooling around with these.

This little baby cranked out some heat. Only issue is I have to clean the exhaust from soot after about 40 to 60 hous use.Well worth the investment.

Watch youtube videos before installing this - this is a typical Chinese diesel heater. The fan was already stuck out of the box - and thanks to youtube I was aware of this common issue before turning it on. You need to open the cover, pull it very hard without breaking it, and calibrate it. It is not something you can setup and use it over night. This is a complicated and tricky device that you need to learn how to assemble, hack it, how to config, how to prime it, etc. The instructions in the box are so bad - rely on other online material.At the end, it worked!

Bought one a few years back for van and still going strong with no problems.. now this is my second to heat garage, good quality and heat out put. New displays a lot different but simpler to use once understood. Just buy one

showed up on time

Uesd it a 6 time and so far it been really good and it got really hot it been -35c out side and with this thing the tent could be at +30

AL MINIMO YA DA MUCHO CALOR. IDEAL --------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

FOD

Really nothing to dislike about it

I bought this to heat my 8X8X7 work shed. Added a fuel filter & raised it with 2X4 for exhaust clearance. I've run it about 12 hours so far & I've been pleased so far. The fasteners on the lower sides often pop open. The display was attached with thin double sided tape.If you don't mind tinkering a little to 'dial it in' based on your needs I don't think you'll be disappointed. I've added a small solar panel to keep the battery charged after use.