Reseñas de clientes para VEVOR Gabinete para servidor de red montaje en pared de 12U, 14,8" gabinete en rack para servidores 200 lbs con paneles laterales de puerta de vidrio con cerradura para equipos de TI, dispositivos A/V

Pros: Price is good, the steel is heavy enough for the job. Neutral: Comes as a flat pack, so you need to assemble it. The knock outs are tricky to remove. Cons: The screws go into tapped sheet metal so don't over tighten or they will strip out. The paint is glossy with a lot of orange peel texture, would have preferred flat black. There is no provisions for mounting a fan, and not enough openings for convection to work completely. The locks require leaving the key in which sticks out. Would have preferred a thumb cam lock with a key.

The item came damaged so the door wont fit. The side dior knobs were also broken so they dont work properly. No damage on the outer cardboard from shipping company. Poor quality on plastic since they were broken.

You get what you pay for.

A little scratched up and frame bent a bit, able to straighten the rails out. Glass door does not fit right have to push hard to close it, I think top frame is bent a bit. For the price, I can live with a few little imperfections.

Came damaged. Not packaged properly. Ver flimsy box

Bars that equipment mount to are too short and will not work. The quality is nice and sturdy but unfortunately, I am going to have to source some correct length bars.

J’ai reçu l’armoire, mais les loquets des portes d’accès de côté sont endommagé. Je crois que c’est l’emballage qui n’est pas bien adapté au transport. Je suis déçu.

Very poorly made. Glass door fell in half from metal hinges.

low quality. flimsy and thin metal. received with some dents even though box was not damaged. locks don't close. have to bend and adjust the locks in order for them to work. low security locks as you can open them with a screw driver. comes with only 1 shelf.

The item arrived and packaging looked OK. No obvious damage. However, the carrier refused to deliver to my address which is in breach of Australian Consumer Law. The steel parts within the packaging were well protected but were bent and damaged requiring a degree of 'panel beating' prior to assembly. Very disappointing. This is completely unacceptable. The way that the server cabinet was packaged appeared to be appropriate and correct. In my opinion the damage was not incurred during transport and the damaged parts were packed in the factory already damaged. I have installed the cabinet with the damage still quite obvious (after being panel beaten), but very disappointing that this kind of rubbish can pass QA and be shipped. No photos attached because I will not be making a claim, but for the amount I paid, thee product is garbage.