Reseñas de clientes para VEVOR Patas de Mesa, 400 X 395 mm Mesa de Comedor de Metal con Marco en X Escritorio Negro, Conjunto de 2 Patas de Mesa de Acero de Calidad, Patas para Muebles Tienda de Café Bar de Oficina en Casa

Content de mon achat malgrè que la table ne tient pas bien sur l

il faudrait mettre des patins sous les pieds reposants au sol, pour une meilleure stabilité car le métal sur le carrelage ce n'est pas adapté

Super pieds de table costaud et design. La qualité est au rendez-vous.

aucun probleme article conforme emballage impeccable delais respectés je recommande

A recommander pour les prochains acheteurs

Produit conforme et livraison rapide

Pieds très robustes, Les vis d’ajustement rendent néanmoins le table un peu branlantes. En les retirant et en posant directement sur les surfaces d’appui des X on supprime le problème. Très satisfait de mon achat!

The legs look great and were uniform. The legs once screwed to the table tended to wobble (about 46 inches apart), as other reviewers stated. The top plate should be wider with more screw holes on both sides would help with stability. I drilled these my self. I also installed 2" steel angle iron between the legs, attaching it inside the top V by drilling two sets of holes in each leg (one in the V and one on either flat - total of 3), on set on out edge of V and other on inside edge, for a total of 6 holes in the angle iron and each leg). I used self-tapping #14 screws, I pre-painted everything black. Came out nice and the table was rock solid.

The table legs are nice looking, great quality and good finish. I custom made a quartz table top for the table legs and used 3/4” plywood to fit inside underneath the table. I also added cross bar pieces of plywood to help support the table from shaking. It’s a lot better now but still shakes a bit. I have 2 suggestions (1) the seams in the table legs need to look seamless as I can see the welding joints at the X (2) the table is unstable even with extra supports (I have quite a bit of supports so it’s now okay but still shakes a bit). I suggest a cross bar at the joining of the X for proper support or at minimum provide the option to buy the support.

It arrived with a few scratches, not well enough packaged, only one layercardboard as protection. Top plate little thin, one mm thicker would have been better. Otherwise nice.