Reseñas de clientes para VEVOR Rejilla de Protección de Canalones 127 mm Protector de Hojas para Canalones Aluminio 26 PCS Longitud 31,7 m Agujero 4 mm Espesor 0,5 mm Protector de Canalones Anti-hojas para Canalones de Tejado

Great cost savings Metal is as thick as Smart Screen Easy to work with Fast shipping Abcdefghijklmnopqrstuvwxyz

I am 73 years old climbing a ladder to clean my gutters is no longer an option. I had a local contractor install . The total cost including labor was less than 1000 compared to a bid of 4700 for leaf guard to install. I love Vevor good products reasonable prices.

Overall decent product,two issues , package came pretty beat up and a number of panels were bent, second the hex bit's magnetic properties leave much to desire. Ended up switching out and using my own

The gutter guards snap into the eavestrough very easily, are simple to install, and even give the gutters some structural rigidity. The supplied screws are not great though. They are self tapping, which is fine, but the tapping end is too large for the thread of the screws, meaning they have no holding power. I stopped using them after installing a few sections and instead used some soffit screws that I had on hand, which secure the guards to the gutters very well. I would recommend that regular soffit screws be supplied with this product instead of the large self tappers.

Great product

Good price, easy to install and seems to work.

The rain gutters are 4 inches impossible to find 4 inch covers so about 5 inch aluminum bent 1 inch chin and they work just fine

matériel livré tres rapidement conforme au descriptif . A voir ultérieurement pour sa tenue dans le temps, mais l'aluminium devrait me satisfaire.

I installed this onto a new colorbond corrugated steel roof with typical "quad" guttering, where the back of the gutter is lower than the front. It was difficult to install, I had to unscrew the roof sheets so I could predrill holes in the fascia (back of the gutter) for the screws. The stainless screws look pretty but won't stay in the bit holder because they aren't magnetic, so also fiddly. The 125mm version wasn't quite wide enough to fit my gutters so I couldn't sit the front edge on top of the gutter. I got the front edge to fit into the slot in the gutter where the support brackets go, but where there was a bracket I had to cut the aluminium so that the panel would push down into the slot either side of the bracket. If they work well the effort will have been worth it, time will tell.

They are easy to install and are beautiful to look at , the only issue is the holes in it don’t stop pine needles from sticking and piling up .