Reseñas de clientes para VEVOR Máquina de Pelacable, Peladora de Cables de Cobre de 1,5-25 mm, Herramienta para Pelar Chatarra de Alambre de Cobre

Figured I’d give this a try thinking it would be ok for the few wires I had to strip. Turns out it is junk and should have known better. Doesn’t it strip wires properly, the shielded wire strips for about 3” and then slides to the side of the blade and doesn’t strip the rest Save your money for a better unit as this one is disappointing

Slechte kwaliteit Ik kan hem niet eens retourneren!

Does not work as announced.Does NOT work with thinner cables.

Didn’t come with safty switch so can’t even use it

NUL. Cette machine à dénuder est une arnaque. Réglage trop minutieux et la plus part du temps impossible pour centrer les engrenages et le disque de coupe. Inutilisable pour des fils de 1.5 ou 2.5mm². Le fil à dénuder sort de l'emplacement de coupe au bout de 2cm.

Never worked from the beginning and can not het any resolve or refund yet will update...

plastic adjusting knob on top broke first time I used it. very cheap. used 2 nuts and James them together. now and use a socket and ratchet to adjust.

This thing is junk. It doesn’t work as advertised

Le moteur ne fonctionne pas et le service méditer remboursé

Very surprised and disappointed at lack of quality check of unit before packing and shipping. Unit came partially assembled, Black plastic handle was already attached to metal handle arm which should attach to main body. Main body comes with a black metal D-shaft section (drive flat section) so as to attach the handle arm securely. The handle arm does not come with a corresponding D shaped hole in the arm,this would have improved its build quality. When trying to attach the handle arm to the shaft, it was noticed that the threaded pilot hole for the M8*12 hexagon screw (item 6 page 5) was not in the correct position on the arm. The M8 threaded hole appears to have been incorrectly installed at the wrong end of the handle arm next to the black plastic cylindrical handle. This has made the unit inoperable unless, we drill and tap the handle arm ourselves or replace the handle arm with an arm incorporating a D-shaft slot and M8 threaded locking screw hole. When you purchase a piece of equipment, we would normally expect to be able to use it fairly quickly once bolted and screwed together. In this situation, unit is unusable until handle issues are resolved.