Reseñas de clientes para VEVOR Máquina de Facetado de Gemas, Pulidora de Roca y Joyas, Máquina de facturación de Gemas Jade plana, 2800RPM

Goede machine, werkt prima. Enigste wat ze nog kunnen verbeteren is rubberen ringetjes onder de schroeven van de lekbak. Komt wat water doorheen bij veel watergebruik. Voorderest perfecte machine.

Olcsó, erős motor, minimális olcsóság érzet és nem tűpontos

This is fantastic quality, all working perfectly. A couple of comments for anyone thinking of buying it - it comes with 1 lap disc, 620 grit. It comes with an EU 2-pin plug, not a UK Plug (I am in Ireland). It requires 2 sockets because there's a water pump included. The instructions don't actually include instructions on how to put the items together, but I found a video on youtube and it was very simple. The water tubing is warped from transport, but I think it will be fine. Fantastic quality and service, as always, from Vevor.

Ist kompliziert zu reinigen

Super Maschine nur der schleifteller dürfte 10cm höher sein um die rondiste besser zu schleifen

Snelle levering, en product is praktisch gebruiksklaar. Let op dat er slechts 1 schijf (korrel 60) is bijgevoegd. Tevens heeft de bijgeleverderde waterpomp een US stekker en dus geen EU/schucko stekker. Zonder omvormer is deze onbruikbaar. (Hier heb ik overigens wel een compensatie voor ontvangen) Verders is het een mooi instapmodel in de wereld van de lapidarist.

je suis satisfait mais pas de notice en francais pour l'ecran. reglage des angles pas precis pour quelque chose qui a besoin de beaucoup de précision. attention au petite decharge electrique au toucher de la machine, pas tres agreable

Polecam na początek chociaż instrukcja jest mało zrozumiała ale. Idzie dojśc co i jak i można zacząć pracować czy do celów hobby wykorzystywać. Fajnie gdyby w komplecie były tarcze różnej gradacji.

Machine needs to be looked over to be level and plumb, bolts and screws should be tightened and situated to ensure proper cuts. Other than that its a good tool to start!

I am using this machine to cab glass. I am enjoying it to a point. I also am using my hands to do this, not all the angled holders and such. Today, I used it for my third or fourth time. These are my issues: During set up 1. A few things were not mentioned in set up procedures and I had to source several different similar machines to see how the water spigot and pump should be set up. They were not described nor displayed. 2. The hoses wouldn’t fit well and I could not do the clamps up tight enough myself so I had to get help. 3. The plastic clamp tighteners feel flimsy **Now, a short time of use. 4. The clamping bands are not stainless so they rust into the water surrounding the pump and the pump might get ruined by this. ** 5. The water dripper handle might be great for small handed lefties (small area and weirdly angled?) but I have small hands and find it awkward. 6 I am having to adjust the water a lot. It seems to run on too slow a drip or too much. 7. The hose coming in is never fully filled but does operate. The one coming out of the machine arrived bent flat at the machine and I have had to add some gravity to assure drainage. It works.