Reseñas de clientes para VEVOR K72-125 Portabrocas de Torno de Mordazas Accesorios de Taladro de Portabrocas de Torno con 1 Llave en T Portabrocas de Torno de 4 Mordazas para Sujetar Ejes Colgantes/Triángulos Equiláteros

You’d think when selling a chuck recommended for the lathe that it would have the same blot pattern. Or an adapter for a 3 bolt mini lathe flange. It does not. Horrible experience with this purchase (lathe was a fiasco) much less a chuck that doesn’t fit without a mod.

Purtroppo la descrizione mi ha portato inganno. Pensavo fosse autocentrante ed invece le quattro viti vanno regolate manualmente per ottenere la centratura

When I received this lathe and turned in on it was running without me turning the speed know. I got ahold of customer service and was told that it was within the limits of 50-1450 rpm even if it's running byl its self at 30 rpm. I told them that my first one didn't run by it's self nor any of the lathe that I saw on YouTube. So they wrote back and stated that it was set like that from that factory and there was nothing wrong. So I decided since they would fix it I bought a new motor and a board. When I installed the new board the old motor didn't run by it's self But it still didn't work right so I change the new motor and it runs fine. One thing else I noticed was the old motor was a 900 watt when In the description of this lathe it said it came with a 750 watt so I not sure if the board that came with the lathe is for a 750 watt Or 900 watt. After all of this it shows that vevor does not stand behind there Equipment and would rather feed you a line of bull instead of fixing The problem. So buyers beware.

Besteld bij de draaibank https://www.vevor.nl/metalen-draaibank-c_10121/mini-draaibank-metaal-220x750mm-mini-draaibank-voor-metaalbewerking-p_010598300757 als extra. Bij levering blijkt deze niet te passen op de draaibank (fout op site?). Ligt nu bij Vevor - benieuwd naar oplossing.

I purchased this for a vevor metal lathe( see that review) the Q&A for the lathe said this chuck would fit. $77.00 later, the chuck has 4 mounting bolts, the lathe spindle has three. Customer support ( if you can call it that) responds—— You will need an adaptor for it. ME: “ what is the part number of the adaptor?” CS: we do not currently offer an adapter. No offer of a return or refund!

Must fabricate things to be able to use it

Good quality. However, it does not fit the Vevor mini lathe. Original chuck has 3 mounting screws and this one has 4.

Me gusta probarlo primero y después hacer el comentario lo recogí ayer que la agencia de transporte fue muy ligera de casco y lo dejó a diez kilómetros de mi casa este es el primer comentario si luego se puede hacer otro del funcionamiento de la pieza de lo haré