Reseñas de clientes para VEVOR Kit de Línea de Compresor de Aire, Sistema de Tuberías de Aire Comprimido Aluminio HDPE, a Prueba Fugas, Resistente a la Presión y Fácil Instalar, para Talleres de Garajes, Azul, Ø 475 x 200 mm

Easy to install and easy to use. Did a great job in my garage.

OTTIMO

This air line kit has been a great upgrade for my workshop setup. The tubing feels very durable, the fittings seal tightly without leaks, and the airflow stays strong and consistent throughout the system. Installation took a little patience because the tubing is fairly stiff, but once everything was mounted it looked clean and worked perfectly. I also appreciated that the kit came with plenty of accessories to get started right away. Overall, it’s a high-quality system that performs well under pressure and feels like it will last for years in a home or professional shop.

I needed 300 feet of no less than 3/4 inch air line for my shop. I looked at all the other materials like PVC. PEX, copper, galvanized steel ect. I was a little reluctant to try this new line as I already was good at installing the other ways and this is new to me. But it was specifically made for this application and Vevor made it affordable. Long story short it is great. easy to install ect. My only complaint as others have said are the parallel threads used on the provided plugs for aluminum blocks provided instead of tapered pipe thread. No amount of tape and goo could seal it. However then I used 1/2 inch tapered thread pipe plugs ( not supplied ) and all was good.

Installed this in my shop before having the shop spray framed. The whole thing is built with quality components!

Not an easy install but worth it. Connectors did not leak. This stuff is stiff and a bit difficult to straighten. I used 1 1/4" PVC as a straightening device.

Super produit livré avec tous les raccords, les fournisseurs locaux vous facturent la même chose 1500€, c’est vraiment abusé

Het materiaal ziet er degelijk uit en het pakket is mooi compleet: slang, koppelingen, t-stuk, hoekjes, slangklemmen. In de handleiding wordt gemeld dat de slang een vrij krappe bocht kan maken, maar het materiaal is zo stug dat dit niet lukt. Voor hobbygebruik is de slang wel onnodig dik. Montagemateriaal ziet er degelijk uit, maar omdat nog niet alles gemonteerd is, is de luchtdichtheid van de kogelkraantjes nog niet te controleren. Als extra heb je nog nodig: slang van compressor naar het 1e aansluitblok, verlopen en snelkoppelingen om slangen aan te sluiten op de outlets.

Appears to be much the same as the first branded kit that Google will find you for almost a third the price. The fittings are easy to use and likely will be more than you'll need. You will likely need more brass plugs than are supplied but these are cheap to obtain from any hardware store. Installation is not a one person job as the hose is very hard to manage. More elbows may be handy but you could possibly use irrigation compression fittings eg Philmac at a pinch. My setup sealed up at first attempt...

3/4" line is a little stiff and not the easiest to get 100% straight but that was to be expected. Fittings and clips are nice with water drains if plumbed correct. No leaks at first with 160 psi line pressure but one of the slide in pipes started leaking in attic after inspection one of the seals had torn not sure if it was pressure or installation that damaged it replaced seal dropped line pressure to 90 psi haven't had any issues since