Reseñas de clientes para VEVOR Cerradura de Puerta Mecánica sin Llave Pestillo Codificado de Aleación de Zinc Teclado de Doble Cara Manija de Puerta de Entrada Izquierda y Derecha Reversible para Espesor de Puerta 35-65 mm

Broke after one week use

I haven't received this item they say it was delivered but we haven't seen it here

This lock broke within a few months. The challenge then became how to remove it. This can only be done from the inside. I had the lock on a door that is at a height with no other access. I had to climb across a very narrow ledge to break into a window. Not a great design, and quite cheaply made.

The lock is SILVER color. The plate supplied on which it is mounted on the door is BLACK. When installed it looks very ugly. The buyer at VEVOR should be cognizant of this and make sure the manufacturer supplies a matching color plate. I took photos and wanted to upload these but that does not seem to work also. OVERALL - a not very happy experience

The lock was damaged, so I'm going to return it

Simple enough to set, fiddly to install on north american door holes as hole & screw placement is different so it wiggles. Biggest flaw is that the passage lock is not reliable. It unlocks, but then locks again. A person could get locked IN if they don’t know the code… I asked for a refund and will replace it. The refund took multiple requests. I Really wanted it to be good!

This door lock has problem with solid studs. The screws provided are not suit for 35mm thickness door. I try to fix this problem with this company , but it takes really time and doesn't work.

Overall, this is a very nice lock time. Will tell if it stands up to repetitive use. I’m giving it a one star because mine is pretty damaged during shipping and looks bad. The install was fairly simple and the instructions were decently written and easy to follow.

This lock may NOT be easy to install. If the depth you are installing the lock across is towards the wider end ( 2.5 inches / 65 mm ) then it will be nearly impossible. The two facings will need to be fully in-place or the spindle will fall out, which means you'll be trying to line up a screw to the back of a standoff that you cannot see. Good luck with that. Also the spindle droops, which makes the whole thing even more challenging. Since the mechanism of the lock proper is machined to receive two 5mm/8 screws, the better solution would be to just buy two long machine screws that fit the width of your mount, so you can actually SEE them stick out the other side and screw them on. BUT know that the rear face depressions only accommodate 4mm screw heads, so a typical 5mm Cap screw wont' fit and will BLOCK the lever on the inside. Just so awesome. Really. So, just be careful. I found a 5mm/8 cap screw whose head was a bit short, just enough so the rear lever could still clear the screw head. Made the installation MUCH easier. I also replaced the spindle with a longer one, which was great because it could be seated deep into the rear lever and thus stuck out straight instead of drooping. Actually, I lied. I first used the 95mm spindle that was included, but it fell into the fence pole. And when I asked for a replacement the service here said "nope". So I had to go source that myself. Thanks! And, as unpleasant as this was, it turns out there aren't a lot of other combination gate locks on the market and my wife likes this one and wants the next one to match. So, I'm buying a second one. Like a chump.

Returns with Vevor is impossible. They run you around in circles. You have been warned.