Reseñas de clientes para VEVOR Elevador de paletas 1T para carretilla elevadora de 1000 kg Horquillas de paletas de carga para elevación de transpaletas Horquillas elevadoras de paletas Todo acero Enganche de 3 puntos 2200L

The center bar broke right away other than that work well

Had high hopes that these would work for doing some lifting of pallets with my Kubota 7800. Tractor had no problem lifting, but the screws on the other hand both had issues. Both bent to a point I can't get them out to replace and one fork bent where I attached a chain to improve stability, the chain bent the metal. Yes I screwed the fork to the bucket and then tightened the bolt. Yes the forks were fully inserted onto the bucket.

El producto llegó bien y pronto. El soporte para la pala y las propias pinzas endebles para los bque yo quiero. Las pinzas se quedan cortas para coger los palets normales y endebles para los 1.000 kg. Cómo podéis ver en la foto los soportes de sujeción se han abierto y el soporte de unión ya está doblado después de utilizarlo en poco uso.

Forks are good but the bolts that clamp on the bucket bend very easy :( Maybe user error but I'm sure the were secure before I moved the logs and pallets Welds on nuts broke so maybe that was the problem and it happened on both forks at seperate times

The 3 point hitch pallet fork might actually work well, but I wouldn’t know because the box was so destroyed by ups when I received it that all the hardware pins were missing. I’m sure they are rolling around in the back of an ups truck somewhere, but that doesn’t do me any good. I’ve contacted VEVOR twice about this and was told both times someone would contact me within 24 hours, but I have yet to hear from anyone.

Kinda bulky, Used on my Backhoe loader probably over did it but bent one fork at the weld trying to lift some logs I cut up Good for light duty IMO but not 4000 lbs a Chevy weighs 3600 lbs LMAO

It work

Item came as pictured, when unboxes i seen the box profile was 3mm wall, i expected 5-6mm wall for the rated weight it should handle, i will be welding on some flat to the sides for extra strength. The first time i used them the bolts to tighten to the bucket bent due to the gap allowing too much movement. I again will need to modify the gap and update the bolt size. Nice idea for a product but in my opinion as standard only fit for very light use.

Good product for the price and they work well. Only complaint is they do slide around your tractor bucket and don’t stay straight even when secured well.

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.