Reseñas de clientes para VEVOR Elevador de paletas 1T para carretilla elevadora de 1000 kg Horquillas de paletas de carga para elevación de transpaletas Horquillas elevadoras de paletas Todo acero Enganche de 3 puntos 2200L

These came in handy when we had material delivered to the farm. They will tend to losen after some use so keep a rubber mallet close by to tighten them back. The brace is great for setting the width, but I found it takes away from the depth when picking up pallets. I'm pleased with them for the occasional use.

Product as described. Functions well on my Deere 1023. Shipping / tracking was VERY BAD! It took longer than expected to arrive.

So far it seems to be working really good if it keeps working like this, I will raise my score to a 5 all the way across

Compression plates won't stay in allowing forks to move around on the bucket because you can't tighten them up enough. But it works

I find that the pallet forks would be better if they actually bolted through the bucket. I can't get them tight enough to keep them from moving. I am satisfied with the weight that I can pick up with them

Forks great just dont fit my bucket well because of step on bucket. Other than that no problem If bucket was flat would mount great. I just got to build something so they will clamp more securely.

These 4000 lb. pallet forks should have come with a stabilizer bar to limit side to side movement, the same as the smaller forks. Also, the screw down rods (2 each fork) would be much better with a nut welded to the plate and the rod would then screw down into the nut. As it is the nut is attached to the screw rod, and as soon as the nut reaches the plate, the whole plate slips and slides sideways. This causes paint to be removed from the plate and constant repositioning of the plate while tightening.. This would not happen if the nut were attached to the plate as the rod would hold the nut and plate in place.

They work great for the price. I wouldn't push them too hard but I have lifted over 1000# without an issue. Would buy again for the price.

Pallet forks are well constructed and very solidly made Unfortunately, had trouble mounting on our tractor bucket being impossible to secure without using a pice of plywood under the clamp both to stop it slipping when tightening The forks could really benefit from having a connector bar between the two to stop side ways movement Other than that have been quite useful but need to stop and tighten after a few uses

I bought these forks because they looked like a perfect fit for my New Holland tractor. Looked perfect when unpacking however I ran into a problem. When trying to attach my lower control arms I found the holes drilled on the bracket were too close to the frame of the fork attachment. I could not put the pin in, the holes should have been an inch farther from the frame. Not sure if I should return or remove and weld on new steel brackets that are a little longer. I willl attach the picture. I the lower arm will be beside the bracket for the picture to show distance is not large enough