Todo perfecto gracias!!

I am quite surprised with this pump so far. It’s a lot more powerful than I was imagining, and compared to my previous HYVA pump, this is like a dream come true. Only issues I had was the SAE thread pattern; because I am in Ireland I had to re-tap the mounting screws. I use this on a 1959 Massey 35 X. PTO does not stick out very far and is not getting the recommended 3 inch purchase, but I still have enough to turn this baby. So be aware if you’re in Europe that the best thing to do is to get orb fittings, trade out the original mounting plugs for orb fittings SAE to BTE, your local farm shop should carry them. Due to the mounting screws being on one side, I had to fabricate a few plates and weld a bracket. It only grabs from one side, which is fine for now, but if I was going to redesign this pump, I would make it so that you could grab the pump on both sides. Not a complaint, just an observation. Make sure you have a fairly large reservoir tank to run this hydraulic pump because it moves a lot of oil quickly. Also, there is not a pressure release inside of the pump except for regular thrust plates, so you may have to adjust your pressure release settings in your valve control on the splitter itself because if you encounter a around with eccentric grain, it can put quite a load on the tractor and actually stall the tractor. For the exceptional price, I will give this pump 4.5 stars. Only 4.5 because for European customers it would be a lot easier to have the standard thread, but if you’re in the United States, no need to worry about it. Yes